0
Owner's of the Bayou Classic Cooktop SP1 gave it a score of 0 out of 5. Here's how the scores stacked up:
TROUBLE SHOOTING TIPS FOR Model #SP1 Jet Cooker
Sometimes the cooker does not light or has a only a meager match flame. Other times, the flame blows
out, bur
ns yellow, or there is a flame inside the burner tube. These symptoms are common and easy to
remedy. The following Trouble Shooting Tips cover most questions and problems associated with outdoor
gas cooker appliances. Save this manual for future reference.
1. SYMPTOM:
Burner lights but the flame remains very small and will not increase for heat-up and cooking.
CAUSE:
Both LP cylinder and regulator couplings contain an EXCESS FLOW safety device that shuts off 90 percent
of gas flow should the hose be cut or severed. Sometimes this safety device can be activated when lighting
the burner. Opening the cylinder valve and/or regulator valve too quickly can create the rapid flow of
gas that activates the excess flow safety device.
POSSIBLE SOLUTION:
Repeat Lighting Instructions steps 1 through 6
on page 16. Follow lighting instructions and
be certain to S-L-O-W-L-Y open cylinder valve
one full turn, then S-L-O-W-L-Y open regulator
valve when lighting.
2. SYMPTOM:
Cooker will not light .
CAUSE:
Orifice hole at bottom of jet tube may not be facing straight up, or has a blockage.
POSSIBLE SOLUTION:
Turn orifice hole to point straight up in jet tube
or clean orifice hole of debris.
1. Using a wrench, turn brass cap at bottom
of jet tube until orifice hole is facing straight up.
2. Using a thin wire; insert into the orifice hole
to remove blockage debris.
Jet Tube
Orifice
Hole
S-L-O-W-L-Y Turn
LP Cylinder V
alve One Full Turn
counter-clockwise
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
S-L-O-W-L-Y
T
urn Regulator Valve ON
counter-clockwise
Flame Spreader
in OPEN Position
30
MODEL #SP1
JET COOKER
Find Your Products By Category
Please Login
