A. ON/OFF button
B. Volume knob
D. Hang holes
E. Seek/tuner/arrow buttons
F. Mode button
G. Clock button
H. Preset button
I. LCD display
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs.
Installing and Removing the Battery Pack
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (J), insert the slide pack or tower stem into
battery receptical until the battery pack is firmly seated. For the stem
pack, be sure that the battery latches are engaged. Refer to Figure3.
To remove battery pack from the radio, firmly pull up or out depending
on the battery type. For the stem pack, press the battery release
buttons before pulling firmly. Insert it into the charger as described in
the charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 4)
EWALT battery packs include a fuel
gauge which consists of three green LED lights
that indicate the level of charge remaining in
the battery pack.
To actuate the fuel gauge, press and hold
the fuel gauge button (K). A combination
of the three green LED lights will illuminate
designating the level of charge left. When the level of charge in the
battery is below the usable limit, the fuel gauge will not illuminate and
the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate unit functionality and is subject to
variation based on product components, temperature and end-user