0

Out of 0 Ratings

Owner's of the Bostitch Nail Gun Bostitch GA Finish Nailer gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 46
 
-9-
1. CONTACT TRIP:
The common operation procedure on “Contact Trip” tools is for the operator to contact the work surface
to actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work
surface is contacted. This will allow rapid fastener placement on many jobs. All pneumatic tools are subject
to recoil when driving fasteners. The tool may bounce, releasing the trip, and if unintentionally allowed to
re-contact the work surface with the trigger still actuated (finger still holding the trigger pulled) an unwanted
second fastener will be driven.
2. SEQUENTIAL TRIP:
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier. The Sequential Trip allows exact fastener location without the
possibility if driving a second fastener on recoil as described under “Contact Trip”. The Sequential Trip Tool
has a positive advantage because it will not accidentally drive a fastener if the tool is contacted against the
work surface - or anything else - while the operator is holding the trigger pulled.
SELECTING THE TRIP MODE:
To ensure safety, the user must lock the trigger (as described on page 8) before changing the trigger
system. To change the trip mode, rotate the mode switch toward the body of the tool. The mode switch will
lock automatically when the indicating arrow is pointing down to the 3 nail icon stamped into the tool frame
(Contact Trip Mode) or to a single nail icon stamped in the tool frame( Sequential Trip Mode). Unlock the
trigger to resume tool operation.
DIAL-A-DEPTH
®
FASTENER CONTROL ADJUSTMENT
The DIAL-A-DEPTH
®
Fastener control adjustment feature provides close
control of the fastener drive depth: from flush with the work surface to shallow
or deep countersink. First set the air pressure for consistent drive in the
specific work as described on page 6, then use the DIAL-A-DEPTH
®
fastener
control adjustment to give the desired depth of drive.
Dial-A-Depth
®
Fastener
Control Adjustment
Sequential Trip Mode
(trip mode selector
switch pointing up)
Contact Trip Mode
(trip mode selector switch pointing down)