5.0
Owner's of the Chamberlain Garage Door Opener WD962KEV gave it a score of 5.0 out of 5. Here's how the scores stacked up:
16
Install the light bulbs
6
To prevent possible OVERHEATING of the end panel or light socket:
• Use ONLY A19 incandescent or compact fl uorescent light bulbs.
• DO NOT use incandescent bulbs larger than 100W.
• DO NOT use compact fl uorescent light bulbs larger than 26W (100W) equivalent.
• DO NOT use halogen bulbs.
• DO NOT use short neck or specialty light bulbs.
NOTE: The use of short neck or speciality light bulbs may overheat the end panel or light socket.
6.1 Pull the top sides of the light lens and
rotate the light lens down.
6.2 Insert an A19 incandescent or
compact fl uorescent light bulb (100
watt maximum), into the light socket.
6.3 Rotate the lens up to close.
Installation
NOTICE
Attach the emergency release rope and handle
Tip: If it is necessary to cut the emergency release rope, seal the cut end with a match or
lighter to prevent unraveling. Ensure that the emergency release rope and handle are above
the top of all vehicles to avoid entanglement.
7
To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
• If possible, use emergency release handle to disengage trolley ONLY when garage
door is CLOSED. Weak or broken springs or unbalanced door could result in an open
door falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage doorway is clear of persons and
obstructions.
• NEVER use handle to pull door open or closed. If rope knot becomes untied, you
could fall.
7.1 Insert one end of the emergency
release rope through the handle. Make
sure that “NOTICE” is right side up. Tie
a knot at least 1 inch (2.5 cm) from the
end of the emergency release rope.
7.2 Insert the other end of the emergency
release rope through the hole in the
trolley release arm. Make sure the
handle is 6 feet (1.83 m) above the
fl oor and secure with a knot.
or
or
Find Your Products By Category
Please Login
