5.0
Owner's of the Chamberlain Garage Door Opener WD962KEV gave it a score of 5.0 out of 5. Here's how the scores stacked up:
25
Option C
FLOOR INSTALLATION
Inside
Garage
Wall
1.1C Carefully measure the position of
both sensor brackets so they will
be the same distance from the
wall and unobstructed.
Use an extension bracket (not provided) or wood block to raise the sensor bracket if needed.
Inside
Garage
Wall
1.2C Attach the sensor brackets to
the fl oor using concrete anchors
(not provided).
(not provided)
1.3C Slide the carriage bolt (H17)
into the slot on each sensor.
H17
Ins de
Garage
Wall
1.4C Insert the bolt through the hole in
the sensor bracket and attach with
the wing nut (H18). The lenses on
both sensors should point toward
each other. Make sure the lens is not
obstructed by the sensor bracket.
H18
Install the Safety Reversing Sensors
1
RED
WHITE
WHITE
GREY
WHITE
WHITE
ED
RED
RED
RE
WH
WHIT
HARDWARE
Insulated Staple (30)
2.1A Run the wire from both sensors
to the garage door opener. Attach
the wire to the wall and ceiling
with the staples.
2.3A Insert the white wires into the
white terminal on the garage door
opener. Insert the white/black wires
into the grey terminal on the garage
door opener.
2.2A Strip 7/16 inch (11 mm) of
insulation from each set of
wires. Separate the wires.
Twist the white wires together.
Twist the white/black wires
together.
Wire the Safety
Reversing Sensors
2
To insert or remove the wires
from the terminal, push in the
tab with a screwdriver tip.
Staple
7/16"
(11 mm)
PRE-WIRED INSTALLATIONS: If your
garage already has wires installed for
the safety reversing sensors, refer to the
instructions on the following page.
INSTALLATION WITHOUT PRE-WIRING
Option A
Find Your Products By Category
Please Login
