FASTENER DEPTH CONTROL ADJUSTMENT
he Fastener Depth Control Adjustment feature provides control of the
ail drive depth from flush with or just above the work surface to shallow
r deep countersink.
TO ADJUST THE FASTENER DEPTH CONTROL:
isconnect tool from air supply before attempting any
parts disassembly and before changing the work
contact element adjustment.
Rotate depth control wheel to give the
desired depth of drive.
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards
Institute, ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side
shielded spectacles and face shields alone do not provide adequate protection.
BEFORE HANDLING OR OPERATING THIS TOOL:
I. READ AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.
II. REFER TO “TOOL SPECIFICATIONS” IN THIS MANUAL TO IDENTIFY THE OPERATING SYSTEM ON
There are two available operation modes on these Bostitch pneumatic tools. They are:
1. SEQUENTIAL TRIP OPERATION 2. CONTACT TRIP OPERATION
1. Push down on pusher lever.
2. Allow pusher spring to pull the
pusher forward until it stops in
the forward position.
3. Slide the nails back to the
ote: Rotate depth control wheel
to give the desired depth of drive.
4. Push down on the nail stop. 5. Slide the nails out of the magazine.
LPF21PL-LPF33PT-LPF28WW_9R189680RC_BOS_MAN_JM_166762RevC_FSeries_Man.qxd 11/26/12 10:30 AM