0
Owner's of the Black & Decker Blower Black & Decker Blower gave it a score of 0 out of 5. Here's how the scores stacked up:
REMOVING BLOW TUBE, VAC TUBE OR COLLECTION BAG (FIGURE 6 & 8)
• To remove the blow tube, vac tube or shoulder collection bag,
depress the release button on the power head and pull straight off
(figure 6 & 8).
OPERATION
USE AS A BLOWER:
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF THE OPERATION IS DUSTY. USE OF RUBBER
GLOVES AND SUBSTANTIAL FOOTWEAR IS RECOMMENDED WHEN WORKING OUTDOORS. FOR
HOUSEHOLD USE ONLY.
WARNING: CUT HAZARD. When turning the tool off for tube installation or any other reason, wait 10 seconds for
the fan to stop rotating before disassembly.
• Do not use in vacuum mode without the vacuum tubes and collection bag in place.
• Always switch off and remove the plug from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become damaged or entangled.
• You leave blower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or working on blower/vac.
• Use blower/vac only in daylight or good artificial light.
ON/OFF SWITCH (FIGURE 9)
Your blower vac is fitted with a two speed switch located on the
top of the power head below the handle.
• To use in low speed, rotate the knob clockwise to Position I. To
use in high speed, rotate the knob clockwise to Position II.
• To turn tool OFF, rotate the knob counterclockwise to the off
position (0).
CORD RETAINER (FIGURE 10)
• A cord retainer is incorporated into the rear of the power head. It
can be used in two different ways:
• To use the cord retainer as shown in figure 10A, hook the
extension cord under the retainer. Then plug the cord from the
power head into the extension cord.
• To use the cord retainer as shown in figure 10B, loop the
extension cord over the power head cord and plug the two ends
into each other. Then hook the extension cord under the retainer.
6
8
9
10
10A
10B
Find Your Products By Category
Please Login
