4.5
Owner's of the DeWalt Saw DeWalt Rolling Miter Saw Stand gave it a score of 4.5 out of 5. Here's how the scores stacked up:
2
English
Carton Contents
1 Rolling miter saw/planer stand
1 Leg extension
1 Storage foot
2 Wheel/storage foot connector (left and right)
2 Extension work support assembly
1 Handle
2 Wheel
2 Axle
2 Work support arms (1 with black cap)
1 Hardware bag:
2 Cord wrap brackets (L, R)
6 M8 x 15 mm buttonhead screws
1 M8 x 25 mm buttonhead screw
6 Curved washers
2 Extension locking knobs
1 M8 lock washer
1 M6 x 10 mm button head screw
1 M6 lock washer
1 Hex wrench
Tools Required
• Hex wrench (supplied)
• Adjustable crescent wrench
• 1/2 inch open end wrench
• 3/4 inch open end wrench
UNPACKING AND CLEANING
Carefully unpack the product and all loose items from the shipping
container(s). Remove the rust-preventative oil from unpainted surfaces
using a soft cloth moistened with mineral spirits, paint thinner or
denatured alcohol.
NOTICE: Do not use highly volatile solvents such as gasoline,
naphtha, acetone or lacquer thinner for cleaning your stand.
Components (Fig. 1)
WARNING: Never modify the stand or any part of it. Damage or
personal injury could result.
Refer to Figure 1 for Components List.
ASSEMBLY
WARNING: PINCH HAZARD. To reduce the risk of serious
personal injury, do not raise or lower stand until the assembly of the
extension work supports is complete.
WRENCH STORAGE (FIG. 3)
The supplied hex wrench (J) comes in the wrench storage location in
the corner of the stand.
ATTACHING THE LEG EXTENSION (FIG. 2, 3)
IMPORTANT: Place stand upside down on the floor or on a level,
stable table as shown in Figure 2.
FIG. 2
Find Your Products By Category
Please Login
