DeWalt Saw DeWalt Rolling Miter Saw Stand User Manual

4.5

Out of 2 Ratings

Owner's of the DeWalt Saw DeWalt Rolling Miter Saw Stand gave it a score of 4.5 out of 5. Here's how the scores stacked up:

  • Reliability

    4.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    4.5 out of 5

  • Performance

    4.5 out of 5

  • Ease of Use

    4.5 out of 5
of 40
 
3
English
1. With stand upside down, insert the leg extension (E) in the
stand(K).
2. Align the holes and install two M8 x 15 mm buttonhead screws (L)
with curved washers (M).
3. Tighten securely with the supplied hex wrench.
E
L, M
J
K
J
FIG. 3
ATTACHING THE WHEEL AND STORAGE FOOT CONNECTOR
(FIG. 4)
1. With stand still upside down, insert the wheel/storage-foot
connector (N) to the stand (K) with wheel extension (O) facing
outward.
2. Align the hole and loosely install one M8 x 15 mm buttonhead
screw (L) with curved washer (M) for later adjustment.
NOTE: The screw will be tightened completely later in the
assembly.
3. Attach the other wheel/storage-foot connector in the same
manner.
N
K
L, M
O
FIG 4
ATTACHING THE WHEELS (FIG. 5)
1. Continuing with stand upside down, remove washer/nut (Q, R)
from axle. Insert axle (P) from the inside of the wheel/storage-foot
connector.
2. Place one of the wheels (D) on the axle with the longer side of the
wheel hub facing inward.
3. Place the washer (Q) on the axle and attach the nut (R). Tighten
the nut.
NOTE: Do not overtighten. Overtightening may cause wheel
rotation to be impaired.

   Find Your Products By Category