removing the depressed center wheel
Always be sure that the tool is switched off and unplugged before installing or removing
Once the edge of the wheel has been
by use, the wheel
worked in both A and
Mount the inner flange onto the spindle.
the wheel on over the inner flange and
screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock
that the spindle cannot revolve,
then use the lock nut wrench and securely
Only actuate the shaft lock when the spin-
dle is not moving.
After operation, always switch
the tool and wait until the wheel has come to a com-
plete stop before putting the tool down.
Hold the tool firmly. Turn the tool on and
then apply the wheel or disc to the work-
In general, keep the edge of the wheel or
disc at an angle
During the break-in period with a new
wheel, do not work the grinder in the
cut into the workpiece.