should never be necessary to force the tool. The weight of the
pressure. Forcing and excessive pressure could cause dangerous when wheel breakage.
worn-out wheel may result in wheel explosion and serious personal
injury. Depressed center wheel should not be used after it has been worn down to
75 mm (3")
diameter for Models 9560CV, 9563CV or 90 mm (3-1/2") for
9561 CV, 9564CV and 9565CV in diameter. Use of the wheel after this point is unsafe and
it should be removed from service and rendered unusable by intentional destruction.
The tools equipped with electronic function are easy to operate because
Electronic speed control for obtaining constant speed
Possible to get fine finish, because the rotating speed is kept constantly even under the
Soft start feature
Safety and soft start because of suppressed starting shock.
When the tool would be employed over the admissible load,
will stop automatically to
protect the motor and wheel. When the load will come to the admissible level again,
tool can be started automaticallv.
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
Repair and maintenance
The tool and its opening vents for cooling
be always kept clean. When the
foreign matters clog such parts. they have
to be taken off.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjust-
ment should be performed by Makita Authorized or Factory Service Centers, always using
Makita replacement parts.