Makita Cordless Saw Slide Compound Miter Saw User Manual

0

Out of 0 Ratings

Owner's of the Makita Cordless Saw Slide Compound Miter Saw gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 37
 
[4] ADJUSTMENT
[4]-3. Guide fence
1) Pretighten M8x25 Hex socket head bolt (with flat washer and spring washer) at the threaded hole designated with gray
arrow. The round shape around the thread hole is smaller than the others (designated with black arrow) for M8x25 Hex
socket head bolts.
2) Do fine adjustment of the right angle between Blade and Guide fence using 1R208.
3) Tighten M8x25 Hex socket head bolt (4pcs.) in order 1, 2, 3, and 4. without moving any parts. (Fig. 73)
Use 1R208 and M8x20 Hex socket head bolt on Arm holder complete to adjust 90 degree angle between Blade and
Turn base. (Fig. 74)
Use 1R207 and M8x20 Hex socket head bolts on the right side and the left side of Arm complete to adjust 45 degree
angle between Blade and Turn base. (Fig. 75)
Note: When tilting the carriage to the right, tilt the carriage to the left slightly after loosening the lever and press Release
button. Tilting the carriage to the left can be done without pushing Release button.
Adjust Maximum cutting depth as follows;
1) Lower Stopper lever to position Blade as shown in Fig. 76.
2) Push the carriage toward Guide fence fully and lower Handle completely. (Fig. 76)
3) Use the hex end of 782232-8 to turn M8x20 Hex socket head bolt until the periphery of Blade extends slightly below
the top surface of Turn base and adjust Blade so that the tip is placed as illustrated in Fig. 77.
Fig. 73
P 24/ 37
Repair
Fig. 74 Fig. 75
Fig. 76
Pretighten M8x25
Hex socket head bolt
Blade
Arm holder complete
Arm complete
1R208
Guide plate
1
2
3
4
[4]-4. Blade
M8x20 Hex socket head bolt
for 90 degree angle adjusting
M8x20 Hex socket head
bolt for 45 degree angle adjusting
Fig. 77
Triangle mark
on Kerf board
255mm
Blade tip
Triangle mark on Kerf board
260mm
Blade tip
4mm
Release button
Stopper lever
Hex end
Carriage
(gray portion)
M8x20 Hex socket head bolt
on Blade case complete
782232-8

   Find Your Products By Category