0
Owner's of the Makita Cordless Saw Slide Compound Miter Saw gave it a score of 0 out of 5. Here's how the scores stacked up:
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Blade case, Motor section (cont.)
ASSEMBLING
(2) Assemble Rod 16 which functions as an axis for Blade case in the order of Figs. 16 17 and 18.
Fig. 16
Fig. 17
Fig. 18
Sleeve 17
Insert Sleeve 17 into
Torsion spring 35.
Torsion spring 35
Front arm
Blade case
Groove for setting the tail of
Compression spring 35
Knob 20
Aligning notch C with Stopper pin, push
Knob 20 toward the notch to lock Blade case
at the lowest position.
notch C
Insert Rod 16 from the left hole of Front arm to the left hole of Blade
case completely until the top end of Rod 16 is flush with the inside of
Blade case as illustrated below.
Knob 20
Put Blade case onto Front arm
while aligning the hole to that of
Front arm in order to pass Rod 16
smoothly in the step of Fig. 15.
Blade case
Front arm
right hole of
Front arm
right hole of
Front arm
right hole of
Blade case
left hole of
Blade case
Aligning notch A with Stopper pin,
push Knob 20 toward the notch to keep
90 degrees between Blade case and Base.
tail
Put one of the tail of Torsion spring 35
into the groove of Front arm.
Knob 20
top end of
Rod 16
top end of Rod 16
Push Rod 16 until the top end reaches
the surface of Front arm through Blade
case and Front arm as illustrated above.
Rod 16
(3) Tighten Torsion spring 35 with M6x20 Hex socket head bolt until the Hex socket head bolt is seated on Blade case.
And tighten Rod 16 with M6x16 Hex socket head set bolt. Refer to right illustration in Fig. 10.
P 9/ 37
Repair
left hole of Front arm
inside of
Blade case
Find Your Products By Category
Please Login
