Makita Cordless Saw Slide Compound Miter Saw User Manual

0

Out of 0 Ratings

Owner's of the Makita Cordless Saw Slide Compound Miter Saw gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 37
 
[4] ADJUSTMENT
[4]-5. Laser (for LS1016L only)
1) Remove M10x20 Hex flange head bolt, Outer flange, Inner flange and Blade.
Then separate Safety cover section from Blade case complete. (Fig. 78)
2) Remove Protector. (Fig. 79)
3) Place Flat washer 16 on Spindle (Fig. 80) and fasten 1R315 and Flat washer 16 by gently tightening M10x20 Hex flange
head bolt as illustrated in Fig. 81.
4) Plug the tool to turn on the laser beam.
WARNING: Do not touch Operation switch. (Fig. 82)
5) Press the upper position (I) of Switch for Laser. (Fig. 82)
6) Slide the position of M5x24 Thumb screw to the center of Laser cover so that a laser beam can be moved as widely as
possible to right or left. (Fig. 83)
7) Move 1R315 to low side and align the laser beam with 1R315 by adjusting M4x6 Hex socket set screw A as illustrated
in Fig. 85.
8) Move 1R315 to high side and align the laser beam with 1R315 by adjusting M4x6 Hex socket set screw B as illustrated
in Fig. 86.
Fig. 78
P 25/ 37
Repair
Fig. 80 Fig. 82
Fig. 83
Fig. 81
Fig. 79
M10x20 Hex flange head bolt
Blade case
complete
Safety cover
section
Switch for
laser
Operation switch
Spindle
Protector
M10x20 Hex
flange head
bolt
1R315
16mm
26mm
Flat washer 16 as
a repairing tool
(Part No. 253771-0)
1mm
M5x24 Thumb screw
Laser cover
Fig. 85 Fig. 86
1R315
M4x6 Hex
socket set
screw A
M4x6 Hex socket set
screw B
1R315
Bring the laser beam
near this groove.
Bring the laser beam
near this groove.
9) Slide the position of M5x24 Thumb screw either right or left to align the laser beam and the groove of 1R315.
And tighten M5x24 Thumb screw.
10) Move 1R315 to low side and align the laser beam and the groove of 1R315 by adjusting M4x6 Hex socket set screw A
as illustrated in Fig. 85.
11) Move 1R315 to high side and align the laser beam and the groove of 1R315 by adjusting M4x6 Hex socket set screw B
as illustrated in Fig. 86.
12) Do fine adjustment by repeating the process 9), 10) and 11).

   Find Your Products By Category